Have Questions?
Factory sample rigid rear fender features relief over skirts to accept fender trim attached by clips. This is fully assembled riveted together with hinge and is drilled for U-clamps. This is not equipped with a tail lamp hole.
Before finishing with primer or paint installer must prepare fender by checking alignment of fender tail and bracket and must be hand fitted at hinge and pin area. Alignment will have to be adjusted and tweaked to fit your components. Fender tail is not drilled or cut-out for tail lamp installation. *NOTE: Optimal updated hinge is available for restorers who would like to replace hinge on our fenders. We suggest pre-fitting fender prioer to painting. *NOTE: Chain panel on left side is part of the fender non-removeable. The body and skirt are one piece! Factory sample is a brand new pre-production parts but may have imperfections on the finished surface. Check threaded and bearing holes for excess plating before installation. There are no physical defects such as cracks or holes there will be cosmetic imperfections only. Sample parts may show marks from installation test and fitment. *NOTE: UPS may consider this part as packaged inchoversize inch for shipment as compared to the actual weight which will result in higher shipping costs.
Measurements: Brackets Width: 3/4 inches
Tech Notes: Suggested to use with #50-0913 Rear Fender Trim Set. *NOTE: We have an updated rear hinge available to replace existing hinge. Must be riveted in place #50-1243 Replica Rigid Rear Fender Hinge.

